Sinclair ASE-24AH Manual de servicio descargar pdf (Pagina 35)

For construction convenience, before laying pipes, use insulation material to insulate the pipes to be deal

with, at the same time, at two ends of the pipe, remain some length not to be insulated, in order to be welded

and check the leakage after laying the pipes.

5.2.3. Insulate for the jointing area, expanding area and the flange area

Insulate for the jointing area, expanding area and the flange area should be done after checking leakage ①

of the pipes

Make sure there’s no clearance in the joining part of the accessorial insulati② on material and local

preparative insulation material.

5.3 Drainage pipe insulation

The connection part should be insulated, or else water will be condensing at the non-insulation part.

5.4 Note

5.4.1 The jointing area, expanding area and the flange area should be heat insulated after passing the

pressure test

5.4.2 The gas and liquid pipe should be heat insulated individually, the connecting part should be heat

insulated individually.

5.4.3 Use the attached heat-insulation material to insulate the pipe connections (pipes’ tie-in ,expand nut ) of

the indoor unit

6. Wiring

Please refer to the Wiring Diagram.

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 45 46

Sin comentarios

Sinclair ASE-24AH Manual de servicio Pagina 35